japanesechinese


NF Corporation
network contact us site map
Google  
home about nf products support news
Measurement Instruments Power Supply and Power Control produts Function Modules Customized Products
home > Products > Measurement Instruments > Signal Generator > Function Generator > WF1947/WF1948 > Features
Product Information

Signal Generator
Multifunction Generator
WF1947/WF1948

# Low noise #
The noise level is reduced to roughly one-tenth of those of previous models* at comparatively high voltage output (about 2Vp-p/50Ω, without DC superposition) and within frequencies of up to 300kHz. By employing an attenuator, the noise level at the low voltage output of about 1Vp-p or lower has been reduced to between a half and one-third those of previous models. In all of the output ranges, dramatic noise reduction has been realized, which makes this product perfect for a wide range of uses.
*Previous models : WF1973/WF1974

# Low distortion #
A complete revision of the circuitry has realized the generation of low-distortion sine waves with total harmonic distortion of 0.04% or less. In addition to the 16-bit resolution of waveform amplitude, high-quality sine waves are produced.(Frequency setting range: 20Hz-20k Hz, amplitude: 0.25Vp-p/50Ω or greater)

# Waveform amplitude resolution: 16 bits #
The circuit structure we developed has realized a 16-bit resolution of waveform amplitude, which is the highest of any oscillator designed for a maximum frequency of 30MHz. High-quality 16-bit resolution of waveform amplitude is provided for all the waveforms you might need, including sine, square and arbitrary waveforms.

#

High amplitude setting accuracy

#

The auto range function facilitates the optimum selection of output voltage range, according to the amplitude and DC offset (including high/low level settings) settings. Further, by reducing the deterioration of the amplitude setting accuracy due to the setting level, it is possible to obtain a very high amplitude setting accuracy.


# Floating #
Each output terminal is insulated from the housing, which makes it possible to connect the terminal to equipment with dissimilar electric potentials. The inclusion of floating output terminals reduces noise caused by ground loops.

# Low fan noise #

The rotational frequency (OR revolution per minute) of the fan is controlled according to the detected ambient temperature. At normal room temperature, excluding start-up and abnormal operation, the noise is one-tenth of that of previous models*.

*Previous models : WF1973/WF1974


back
top of this page