Driving the future of technology : Original solution in measurement and control

 Support

Software download

Control Software for EC series

File Info Control Software for EC Series Ver1.2.0.0
Description Control Software for EC Series is a program to support the Remote control, Arbitrary waveform creation, Sequence functions of Programmable AC/DC Power Source EC series.
Instruction Manual www.nfcorp.co.jp/english/doc_portal/index.html
Applicapable Models EC750SA/EC1000SA/EC750S/EC1000S
Operating Environment
  • OS: Windows 7 (32bit / 64bit), Windows 8.1 (32bit / 64bit), Windows 10 (32bit / 64bit)
  • Free Hard Drive Space: 64MB or more
  • VISA: NI-VISA Ver16.0 or later
Installation Procedure
  • 1. Uninstall any previous version if installed.
  • 2. Unzip the downloaded file [EC_ControlApplication_V120_En.zip].
  • 3. Execute [SetupEn.msi] from unzipped folder.
  • 4. Follow the instructions on the installer to complete the installation.
USB Driver Software The NFUSBTMC driver described in "Installation of USB Driver Software" in Section 2.2.1 of the instruction manual is provided only on the CD-ROM supplied with the product. If you do not have a CD-ROM, please use NI-VISA from National Instruments Corporation. For details, refer to Section 2.2.1 "Installation of USB Driver Software" in the instruction manual.
The NFUSBTMC driver can be used only in Windows 7.It can not be used with Windows 8.1/10.
Software License Agreement By downloading this software, you accept and agree to be bound by the terms of the software license agreement that appears below.
Please read this software license agreement carefully before downloading

  •  License Grant and Right of Use:
    NF Corporation (NF) grants you a limited, non-exclusive license to use the software according to the applicable terms set forth below, subject to your compliance with this agreement. NF reserves the copyright of the software.

  •  Transfer to a Third-party:
    If you transfer or redistribute this software to a third party, please attach this "Software License Agreement" on your own responsibility.
    The same terms and conditions applies when the software is redistributed in magazines.

  •  Restrictions:
    May not modify the software; nor disassemble, decompile or othervise reverse engineer the software.
    May not use any part or all of the software for the purpose of developing a new software.
    On the other hand, when downloaded files contains the software has permitted development rights as device driver and sample program, may use all or part of software at the own software development.

  •  Disclaimer of Warranty:
    NF disclaim all warranties and conditions, express or implied for any consequential damages caused by usage of software and attached documents. In no event will NF be liable to correct or support any inaccuracy or incompleteness of the software and attached documents.

  •  High Risks Activities:
    The software is not fault tolerant, and it is not suitable to use in any hazadous environment that requires fail-safe function. The software is also not suitable for any activities that may result in death, injury and incidental damage (collectively, high risk activities). NF expressly disclaims all warranties, either express or implied regarding applicability to high risk activities.
Download of software EC_ControlApplication_V120_En.zip  [Approx. 2.92MB]

Download

back to the page top