Support
Software download
Control software for WF1983 / WF1984 Ver. 1.00
File Info |
Control Software for WF1983/WF1984 Ver.1.00 |
Description |
This is the latest version of the control software for WF1983/WF1984. The control software is a program with basic controller, sequence editing, and arbitrary waveform creation functions. It can set the basic parameters, create and edit various types of data. |
Operating Environment |
- OS: Windows 10/11 (64bit)
- Free Hard Drive Space: 64MB or more
- Interface: USB/LAN
- Microsoft.NET Framework 4.8 or later must be installed.
|
Instruction Manual |
Instruction Manual
/english/doc_portal/index.html
|
Installation Procedure |
- 1. Unzip the downloaded file and run "setup.exe".
- 2. Install the software according to what is displayed.
|
Software License Agreement |
By downloading this software, you accept and agree to be bound by the terms of the
software license agreement that appears below.
Please read this software license agreement carefully before downloading
-
License Grant and Right of Use:
NF Corporation (NF) grants you a limited, non-exclusive license to use the
software according to the applicable terms set forth below, subject to your
compliance with this agreement. NF reserves the copyright of the software.
-
Transfer to a Third-party:
If you transfer or redistribute this software to a third party, please
attach this "Software License Agreement" on your own responsibility.
The same terms and conditions applies when the software is redistributed in
magazines.
-
Restrictions:
May not modify the software; nor disassemble, decompile or othervise reverse
engineer the software.
May not use any part or all of the software for the purpose of developing a
new software.
On the other hand, when downloaded files contains the software has permitted
development rights as device driver and sample program, may use all or part
of software at the own software development.
-
Disclaimer of Warranty:
NF disclaim all warranties and conditions, express or implied for any
consequential damages caused by usage of software and attached documents. In
no event will NF be liable to correct or support any inaccuracy or
incompleteness of the software and attached documents.
-
High Risks Activities:
The software is not fault tolerant, and it is not suitable to use in any
hazadous environment that requires fail-safe function. The software is also
not suitable for any activities that may result in death, injury and
incidental damage (collectively, high risk activities). NF expressly
disclaims all warranties, either express or implied regarding applicability
to high risk activities.
|
Download of software |
WF198x_ControlSoftware_1_0_0_0_En.zip [Approx. 2.8MB]
Download
|